Related Manuals for Edwards FL20K
Summary of Contents for Edwards FL20K
- Page 1 A133-99-880 Issue E Original Instruction Manual FL20K Foreline Trap Description Item Number FL20K A133-05-000...
- Page 2 This page has been intentionally left blank.
-
Page 3: Table Of Contents
Figure Page Component parts of the FL20K ..................2 Dimensions (mm) ......................3 Component parts of the basket assembly ................5 © Edwards Limited 2013. All rights reserved. Page i Edwards and the Edwards logo are trademarks of Edwards Limited. - Page 4 Tables Table Page Checklist of items ......................4 Associated publications Publication title Publication number Vacuum pump and vacuum system safety P400-40-100 Page ii © Edwards Limited 2013. All rights reserved. Edwards and the Edwards logo are trademarks of Edwards Limited.
-
Page 5: Introduction
The units used throughout this manual conform to the SI international system of units of measurement. General Description The FL20K has been developed for use in clean pumping systems to prevent the back-migration of rotary pump oil vapour into the systems; we particularly recommend that you use an FL20K with two-stage rotary pumps. -
Page 6: Component Parts Of The Fl20K
5. Compression spring 2. Wing nut 6. Lid 3. Body 7. O-ring 4. Basket A. Clearance required for removal of basket (4) Page 2 © Edwards Limited 2013. All rights reserved. Edwards and the Edwards logo are trademarks of Edwards Limited. -
Page 7: Technical Data
1 bar absolute, 1 x 10 Mechanical data Dimensions Figure 2 Mass 1 kg Sorbent charge 0.07 kg Figure 2 - Dimensions (mm) © Edwards Limited 2013. All rights reserved. Page 3 Edwards and the Edwards logo are trademarks of Edwards Limited. -
Page 8: Installation
1. If necessary, however, you can mount the FL20K in any orientation, as the sorbent is securely retained in the basket. The mass of the FL20K will be adequately supported by the pipeline connections and you can connect either port to the rotary vacuum pump. -
Page 9: Component Parts Of The Basket Assembly
2. Activated alumina 7. End disk 3. Basket 8. Compression spring 4. Spindle 9. Wing nut 5. End disk 10. Washer (M6) © Edwards Limited 2013. All rights reserved. Page 5 Edwards and the Edwards logo are trademarks of Edwards Limited. -
Page 10: Operation
Regular regeneration by baking the trap or renewal of the sorbent will be necessary for rapid pump-down. If the FL20K has been open to atmosphere for a long period of time, it may be necessary to carry out ... -
Page 11: Maintenance
The time taken for this to occur depends on the frequency of use and the location of the trap in relation to the rotary pump. A typical charge life is six months, although Edwards recommends that you change the charge every three months as a routine maintenance procedure. -
Page 12: Storage And Disposal
2. Store the FL20K in clean dry conditions, away from direct sources of heat and sunlight. Disposal Dispose of the FL20K safely and in accordance with all local and national safety and environmental requirements. Page 8 © Edwards Limited 2013. All rights reserved. -
Page 13: Spare And Accessories
Edwards products, spares and accessories are available from Edwards companies around the world. The majority of these centres employ people who have undergone comprehensive Edwards training courses. Order spare parts and accessories from your nearest Edwards company or distributor. When you order, please state for each part required: Model and Item Number of your equipment ... - Page 14 A133-99-880 Issue E This page has been intentionally left blank. Page 10 © Edwards Limited 2013. All rights reserved. Edwards and the Edwards logo are trademarks of Edwards Limited.
Need help?
Do you have a question about the FL20K and is the answer not in the manual?
Questions and answers