About This Document; General Safety Instructions - Bosch Rexroth IMenip Instruction Manual

16/76 Bosch Rexroth AG
1

About this document

This manual contains important information
on the safe and appropriate assembly,
transportation, commissioning, operation,
maintenance, disassembly and simple
troubleshooting of the IMenip interface
module.
Read these instructions completely,
especially the chapter "2 General safety
instructions" on page 16 before working with
the IMenip interface module.
Related documents
The IMenip interface module is a system
component.
Also observe the instructions for the other
system components.
Also observe the generally applicable, legal
or otherwise binding regulations of the
European or national legislation and the rules
for the prevention of accidents and for
environmental protection applicable in your
country.
2 General safety
instructions
The IMenip interface module has been
manufactured according to the accepted
rules of current technology. There is,
however, still a danger of personal injury or
damage to equipment if the following general
safety instructions and the warnings before
the steps contained in these instructions are
not complied with.
• Read these instructions completely and
thoroughly before working with the IMenip
interface module.
• Keep these instructions in a location where
they are accessible to all users at all times.
IMenip | 3 609 929 B63/2008-09
• Always include the operating instructions
when you pass the IMenip interface
module on to third parties.
Intended use
The IMenip interface module is a component
in terms of the machine directive 98/37/EC
and is not a ready-for-use machine. The
product is exclusively intended for being
integrated in a machine or system or for being
assembled with other components to form a
machine or system.
The product may be commissioned only if it is
integrated in the machine/system for which it
is designed and the machine/system fully
complies with the EC machine directive.
Observe the operating conditions and
performance limits specified in the technical
data.
The IMenip interface module is a work
appliance and not designed for private use.
Intended use includes having read and
understood these instructions, especially the
chapter "2 General safety instructions".
The IMenip interface module is intended for
installation in components for the Tightening
System 350.
Improper use
Any use of the IMenip interface module other
than described in chapter "Intended use" is
considered as improper.
Personnel qualifications
Assembly, commissioning and operation,
disassembly, service (including maintenance
and repair) require basic electrical and
mechanical knowledge, as well as
knowledge of the appropriate technical
terms. In order to ensure operating safety,
these activities may therefore only be carried
out by qualified technical personnel or an
instructed person under the direction and
supervision of qualified personnel.