Status: User Interface Lcd; To Operate The User Interface; Before Operation; Overview: Before Operation - Daikin FTXTA30A2V1BW User Reference Manual

f Horizontal swing button
g Comfort airflow and Intelligent eye operation button
h Select button
i Clock button and open panel (push 2 seconds)
j Buttons for ON/OFF timer operation
k Buttons for Weekly timer operation
l Streamer and Fireplace logic
m Econo and Outdoor unit quiet operation button
n Mode button
o Powerful button
p Fan button
INFORMATION
Use (hold for 2 seconds) to open the front panel when
you clean the air filters. See
panel" on page 17.
3.2.2

Status: User interface LCD

Icon
Operation is active
Operation mode = Automatic
Operation mode = Drying
Operation mode = Heating
Operation mode = Cooling
Operation mode = Fan only
Powerful operation is active
Econo operation is active
Outdoor unit quiet operation is active
The indoor unit receives a signal from the user
interface
Current temperature setting
Airflow rate = Automatic
Airflow rate = Indoor unit quiet
Airflow rate = High
Airflow rate = Medium high
Airflow rate = Medium
Airflow rate = Medium low
Airflow rate = Low
FTXTA30A2V1BW
Split system air conditioner
4P518786-4D – 2019.04
"7.4 To open the front
Description
Icon
Comfort operation is active
Intelligent eye is active
Automatic vertical swing is active
Automatic horizontal swing is active
Streamer is active
Fireplace logic is active
ON timer is active
OFF timer is active
Weekly timer is active
Day of the week
Current time
3.2.3

To operate the user interface

a
≥500
(mm)
a Signal receiver
Note: Make sure that there are no obstacles within 500 mm under
the signal receiver. They may influence reception performance of the
user interface.
1 Aim the signal transmitter at the signal receiver on the indoor
unit (maximum distance for communication is 7 m).
Result: When the indoor unit receives a signal from the user
interface, you will hear a sound:
Sound
Beep-beep
Beep
Long beep
4

Before operation

4.1

Overview: Before operation

This chapter describes what you have to do before operating the
unit.
Typical workflow
Before operation usually consist of the following stages:
▪ Fixing the user interface to the wall.
▪ Inserting the batteries in the user interface.
▪ Setting the brightness of the user interface display.
▪ Setting the clock.
▪ Setting the indoor unit position.
▪ Turning on the power supply.
4 Before operation
Description
Description
Operation starts.
Setting changes.
Operation stops.
User reference guide
5