Postrequisite; Setting The Time Zone And Date - Symantec NetBackup 5000 Replacement Manual

Step 16
Step 17
Step 18
Step 19
Step 20
Step 21
Step 22
----End

Postrequisite

After the chassis is replaced, label the replaced chassis for the convenience of subsequent
handling.
After the chassis is replaced, perform the following procedure to set the time zone and date:
1.
2.
3.
Figure 1-2 YaST control center
NBU 5000 Chassis Replacement Guide v. 1.3
NetBackup 5000 Chassis Replacement v. 1.3
Install the DIMMs. For details, see Error! Reference source not
found. to Error! Reference source not found. in Error! Reference
source not found."Error! Reference source not found.".
Install the windshield over the CPU. For details, see Error! Reference
source not found. in Error! Reference source not found."Error!
Reference source not found.".
Install the rear cover of the chassis. For details, see Error! Reference
source not found. in Error! Reference source not found."Error!
Reference source not found.".
Install the disk modules. For details, see Error! Reference source not
found. to Error! Reference source not found. in Error! Reference
source not found.Error! Reference source not found..
Install the new NetBackup 5000 into the cabinet. For details, see
Error! Reference source not found. in Error! Reference source not
found."Error! Reference source not found.".
Connecting the NetBackup 5000 to the power socket and the KVM.
Press the Power button on the rear of the cabinet to power on the
NetBackup 5000.
Connect the KVM on device, ensure CPU, memory and RAID card
message is correct in system self-test post;
Login with credentials: root/root.
Type yast at the command prompt to start the YaST control center.