Procedure - Symantec NetBackup 5000 Replacement Manual

Procedure

Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
Step 9
Step 10
Step 11
Step 12
Step 13
Step 14
Step 15
NBU 5000 Chassis Replacement Guide v. 1.3
NetBackup 5000 Chassis Replacement v. 1.3
Wear the ESD-preventive clothes, ESD-preventive wrist strap, and
ESD-preventive gloves. For details on how to wear the
ESD-preventive wrist strap, see Wearing the ESD-Preventive Wrist
Strap in Error! Reference source not found."Error! Reference
source not found.".
Power off the NetBackup 5000 and disconnect the NetBackup 5000
from the power sockets and external devices.
Smoothly pull the NetBackup 5000 out of the cabinet, and lay the
NetBackup 5000 on a grounded and ESD-free operating platform. For
details, see Error! Reference source not found. in Error! Reference
source not found."Error! Reference source not
Remove the disk modules. For details, see
not found. to Error! Reference source not found.
Reference source not found."Error! Reference source not
Open the rear cover of the chassis. For details, see Error! Reference
source not found. in Error! Reference source not found."Error!
Reference source not found.".
Remove the wind cover over the CPU cooling fin. For details, see
Error! Reference source not found. in Error! Reference source not
found."Error! Reference source not found.".
Remove the DIMMs. For details, see Error! Reference source not
found. to Error! Reference source not found. in Error! Reference
source not found."Error! Reference source not found.".
Remove the CPU and cooling fin. For details, see Error! Reference
source not found. to Error! Reference source not found. in Error!
Reference source not found."Error! Reference source not found.".
Remove the RAID card. For details, see Error! Reference source not
found. to Error! Reference source not found. in Error! Reference
source not found."Error! Reference source not found.".
Remove the NIC. For details, see Error! Reference source not found.
and Error! Reference source not found. in Error! Reference source
not found."Error! Reference source not found.".
Move the new NetBackup 5000 chassis on the operating platform.
Install the RAID card. For details, see Error! Reference source not
found. to Error! Reference source not found. in Error! Reference
source not found."Error! Reference source not found.".
Install the NIC. For details, see Error! Reference source not found.
to Error! Reference source not found. in Error! Reference source
not found."Error! Reference source not found.".
Connect the internal cables of the main board. For details, see the
instructions on the back of the rear cover of the NetBackup 5000
chassis.
Install the CPU and cooling fin. For details, see Error! Reference
source not found. to Error! Reference source not found. in Error!
Reference source not found."Error! Reference source not found.".
found.".
Error! Reference source
in Error!
found.".