Using The Hdmi Settings Feature - Toshiba REGZA 42LX177 Owner's Manual

To set the CE-Link Setup:
Press Y and open the Setup menu.
1
Highlight CE-Link Setup and press T.
2
Setup
Installation
CE-Link Setup
Sleep Timer
HDMI Settings
PC Settings
Slide Show Interval
Power-On Mode
Power-Saving
Demo Mode
3
Press B or b to highlight Enable CE-Link.
CE-Link Setup
Enable CE-Link
TV Auto Input Switch
TV Auto Power
Device Auto Standby
Speaker Preference
Reset
4
Press C or c to select On.
Note: If you set Enable CE-Link to Off, the all other items
will be grayed out.
5
Press B or b to highlight the CE-Link setup item you
want to use, and press C or c to select On/Off or the
desired speakers mode.
TV Auto Input Switch: On/Off
•
TV Auto Power: On/Off
•
Device Auto Standby: On/Off
•
Speaker Preference: TV Speakers/Audio Receiver (See
•
details on the previous page.)
CE-Link Setup
Enable CE-Link
TV Auto Input Switch
TV Auto Power
Device Auto Standby
Speaker Preference
Reset
To save the new settings, highlight Done and press T.
6
To revert to the factory defaults, highlight Reset and
press T.
Chapter 6: Using the TV's features
2 Sec
On
On
On
Off
On
TV Speakers
Done
On
On
Off
On
TV Speakers
Done

Using the HDMI settings feature

This menu consists of the following 3 items (new HDMI
capabilities) and will be grayed out on non-HDMI inputs.
Some HDMI legacy sources may not work properly with your
HDMI TV, please try setting the following three options (Lip-
Sync Latency, Deep Color, and xvYCC) to Off. Adjusting
these settings should allow your HDMI legacy source to
operate properly with your TV.
Lip-Sync Latency: On
•
This option activates an auto audio/video display timing
adjustment function that allows HDMI source devices to
accurately perform synchronization automatically.
Deep Color: On
•
This feature allows to HDMI source to increase available
colors bits within the boundaries defined by the RGB or
YCbCr color space.
xvYCC: On
•
This feature expands the acceptable color range (limits) in
the HDMI signals, then allows sending wider color signals
from HDMI source.
All above HDMI settings need proper HDMI source device.
If HDMI source products does not support these features,
the TV may not work properly by activating these features.
Note: If your HDMI connection is capable of 1080p and/or
your TV is capable of refresh rates greater than 60Hz or
supports Deep Color, you will need a Category 2 cable.
Conventional HDMI/DVI cables may not work properly with this
mode.
To set the HDMI Settings:
1
Select the appropriate HDMI input mode (HDMI 1,
HDMI 2, or HDMI 3).
Press Y and open the Setup menu.
2
Highlight HDMI Settings and press T.
3
4
Press B or b to highlight the item you want to set.
HDMI Settings
Lip-Sync Latency
Deep Color
xvYCC
Once you have changed On/Off settings, please press
Done and wait for changes completed message.
Warning: DO NOT TURN OFF OR UNPLUG THE TV UNTIL
COMPLETED MESSAGE IS DISPLAYED!!
Reset
5
Press C or c to select On or Off .
To save the new settings, highlight Done and press T.
6
To revert to the factory defaults, highlight Reset and
press T.
HDMI 1
On
On
On
Done
75