Selecting The Color Temperature; Using The Vertical Edge Enhancer Feature - Toshiba REGZA 42LX177 Owner's Manual

Selecting the color temperature

You can change the quality of the picture by selecting from
three preset color temperatures (Cool, Medium, and Warm), as
described below.
Mode Picture Quality
Cool blueish
Medium neutral
Warm reddish
To select the color temperature:
Press Y and open the Video menu.
1
Highlight Picture Settings and press T.
2
Highlight Advanced Picture Settings and press T.
3
Highlight Color Temperature and press T.
4
Advanced Picture Settings
Dynamic Contrast
Static Gamma
Color Temperature
Vertical Edge Enhancer
Cinema Mode
ClearFrame
Film Stabilization
Reset
5
In the Color Temperature field, select the mode you
prefer (Cool, Medium, or Warm).
Color Temperature
Color Temperature
B Drive
G Drive
Reset
6
Press B or b to select either B Drive or G Drive, and
then press C or c to adjust the settings.
B Drive
G Drive
B Drive: c makes the picture blueish.
•
G Drive: c makes the picture greenish.
•
Note: The B Drive and G Drive settings are connected to
the Color Temperature settings and will change based
on which setting is selected in step 5 above.
To save the new settings, highlight Done and press T.
7
To revert to the factory defaults, highlight Reset and
press T.
Note: If you select one of the factory-set picture modes
(Sports, Standard, Movie, or Document) and then
change the color temperature mode, the picture mode
automatically changes to Preference.
78
Chapter 7: Using the TV's advanced features
Mode: Preference
Off
0
Cool
High
Film
On
Off
Done
Mode: Preference
Cool
0
0
Done
1
1

Using the Vertical Edge Enhancer feature

The Vertical Edge Enhancer feature strengthens video contour.
To turn on the Vertical Edge Enhancer feature:
Press Y and open the Video menu.
1
Highlight Picture Settings and press T.
2
Highlight Advanced Picture Settings and press T.
3
4
In the Vertical Edge Enhancer field, select the mode
you prefer (Off, Low, Middle, or High).
Advanced Picture Settings
Dynamic Contrast
Static Gamma
Color Temperature
Vertical Edge Enhancer
Cinema Mode
ClearFrame
Film Stabilization
Reset
To save the new settings, highlight Done and press T.
5
To revert to the factory defaults, highlight Reset and
press T.
Note:
• If you select one of the factory-set picture modes (Sports,
Standard, Movie, or Document) and then change the
Vertical Edge Enhancer setting, the picture mode
automatically changes to Preference.
• When the input is changed to PC, this feature is
automatically set to High and grayed out in the menu.
Mode: Preference
Off
0
Cool
High
Film
On
Off
Done