Handlebar Switches - Yamaha MT07 TRACER Owner's Manual

Handlebar switches

Left
1
2
3
4
1. Pass switch " "
2. Dimmer switch "
3. Turn signal switch "
4. Horn switch " "
Right
1. Start/Engine stop switch "
2. Hazard switch " "
Pass switch " "
Press this switch to flash the headlight.
TIP
When the dimmer switch is set
to " ", the passing switch has no ef-
fect.
Dimmer switch "
Set this switch to "
beam and to " " for the low beam.
Instrument and control functions
EAU1234K
/ "
/ "
1
2
/ / "
EAU12352
EAU12401
/ "
" for the high
Turn signal switch "
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
Press this switch to sound the horn.
Start/Engine stop switch " /
To crank the engine with the starter,
set this switch to "
the switch toward "
for starting instructions prior to starting
the engine.
Set this switch to "
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
Hazard switch " "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of an
emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
3-13
EAU12461
/ "
". When
EAU12501
"
EAU68270
/
", and then slide
". See page 5-2
" to stop the en-
EAU12735
" posi-
ECA10062
3
"