Overview; Features - sparkfun Artemis Integration Manual

1.Overview

The SparkFun Artemis is a Cortex-M4F based BLE module using the Apollo3 micrcontroller from Ambiq. The
Artemis is capable of running machine learning algorithms with the low current consumption of 6 μA/MHz at
3.3V. The Artemis has an integrated 2.4GHz antenna and incorporates all the necessary circuitry to implement
a low power BLE enabled microcontroller.

2.Features

Ultra-low supply current
- 6μA/MHz executing from flash at 3.3V
- 1μA deep sleep mode (BLE Off) with RTC at 3.3V
- Supply voltage: 1.75V to 3.63V with onboard DC/DC regulation
High-performance ARM Cortex-M4 Processor
- Up to 48 GPIO
- 48 MHz nominal clock frequency, with 96 MHz burst mode
- Floating point unit
- Memory protection unit
- Wake-up interrupt controller with 32 interrupts
- Up to 1 MB of flash memory for code/data
- Up to 384 KB of low leakage RAM for code/data
- 16 kB 2-way Associative/Direct-Mapped Cache
Integrated Bluetooth 5 low-energy module
- RF sensitivity: -93 dBm (typical)
- TX: 3 mA @ 0 dBm, RX: 3 mA
- TX peak output power: 4.0 dBm (max)
Small Size
- 15.5 x 10.5mm including antenna
Easy Integration
- Large SMD pads and spacing allow for low cost 2-layer carrier board implementations
- Programming over pre-configured serial bootloader or JTAG
Ultra-low power ADC
- 14 bit ADC at up to 2.67 MS/s effective continuous, multi-slot sampling rate
- 15 selectable input channels
- Voltage Comparator
SparkFun Electronics Inc - Artemis Integration Guide - 1p0p3 3