Regulator Testing And Configuration; Regulatory Statements - sparkfun Artemis Integration Manual

9.Regulator Testing and Configuration

If necessary the Artemis module can be configured for host product evaluation for different operational
conditions. In other words, if Artemis is implemented into a host system that needs secondary certifications the
Artemis can be loaded with test firmware to put the radio into different constant transmission or reception
states to verify the end device does not emit spurious ​
documentation for implementation is located in the Ambiq SDK under 'uart_ble_bridge'.

10. Regulatory Statements

FCC Statements
FCC Statements
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that may cause undesired
operation.
Cet appareil est conforme à la section 15 des réglementations de la FCC. Le fonctionnement de l'appareil est
sujetaux deux conditions suivantes :
1) cet appareil ne doit pas provoquer d'interférences néfastes, et
2) cet appareil doit tolérer les interférences reçues, y compris celles qui risquent de provoquer un
fonctionnement indésirable.
Note:​ This product has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This product generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this product does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning:​ Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End
users must follow the specific operating instructions for satisfying RF exposure compliance.
SparkFun Electronics Inc - Artemis Integration Guide - 1p0p3
e missions caused by the Artemis. The test firmware and
16