Sec - Omega DP25B-E User Manual

SECTION 8. SPECIFICATIONS (Continued)
ALARM OUTPUTS (if applicable)
ANALOG OUTPUT (if applicable)
Signal Type:
Signal Level:
Function:
Linearity:
Step Response Time:
ISOLATED ANALOG OUTPUT (TB5, if applicable)
Same as non-isolated analog output except isolated.
Signal Type:
Signal Level:
Function:
Linearity:
Step Response Time:
Isolation
• Only one analog output is available on each unit and it must be factory
Note
installed.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
2 Form "C" on/off relays. Configurable for latched and
unlatched by software.
Max current: 5 AMPS, resistive load
Max voltage: 250 Vac or 30 Vdc
Current or voltage
Current: 10 V max compliance at 20 mA output
Voltage: 20 mA max for 0-10 V output
May be assigned to a display range or proportional
control output with Setpoint #1 when used as a control
output.
0.2%
2 - 3 seconds to 99% of the final value
Current or voltage
Current: 10 V max compliance at 20 mA output
Voltage: 20 mA max for 0-10 V output
May be assigned to a display range or proportional
control output with Setpoint #1 when used as a control
output.
0.2%
2 - 3 seconds to 99% of the final value
130 Vrms working voltage, 1000 V/60sec Dielectric test
Specifications
8
53