Eastwood 28135 Instructions Manual page 7

USE OF THE SUPPORT PIN WITH THE SQUARE STOP BLOCK
• Insert the Support Pin [L] in the hole so that it is
located under the Square Stop Block [M] but does
not block a 15mm x 120mm Long Hitch Pin [G] from
passing through the hole in the Square Stop Block
[M] and into the lower hole of the "U" of the Ring
Assembly/Die Receiver [B] (Fig. 4).
If the Stop Block [M] is correctly placed,
it should not be necessary to clamp the
workpiece into place. If high precision is
required however, it may be helpful to clamp
the workpiece into place with Vice-Grip type
clamping pliers (Not Included).
PLACEMENT OF DIE
Dies are placed at one or two different locations depending
on the bend to be made.
• A Die can be used in conjunction with the 15mm x
120mm Long Hitch Pin [G] at the intersection of the
Handle/Die Receiver [E] and the Ring Assembly/Die
Receiver [B].
• The Die can also be placed on the Handle/Die Receiver
[E] using a 15mm x 95mm Short Hitch Pin [H].
• Two Dies can be placed so that one is on the
Handle/Die Receiver [E] and one at the center
point where the Handle/Die Receiver [E] and Ring
Assembly/Die Receiver [B] intersect (Fig 5).
ORIENTATION OF HANDLE
The Handle is always oriented Up and on the Right side. The Handle is always moved clockwise when a bend is being made.
To order parts and supplies: 800.343.9353 >> eastwood.com
FIG. 4
 """"
FIG. 5
 """"
Die Location
 """"
B.
M.
Stop Block
Stop Support Pin
B.
G. H.
B.
B.
Die Location
G.
E.
L.
E.
Die
Location
Die
Location
G.
7