Eastwood 28135 Instructions Manual page 5

BENDER ASSEMBLY
• Place the Handle/Die Receiver [E] "U" inside the larger "U" of the Ring Assembly/Die Receiver [B] and secure it in place by inserting a Long 15mm x
120mm Hitch Pin [G].
• Slide the tubular Handle Extension with rubber grip [F] into the larger diameter tubular section of the Handle/Die Receiver [E]. NOTE that there are two
sets of holes. For normal use, align the outermost hole of the Handle Extension [F] with the holes in the Handle/Die Receiver [E] then place the 6mm x
40mm Hitch Pin [J] through the holes and secure with the Pin Clip [K]. For projects requiring more leverage, remove the Pin Clip and Hitch Pin, extend the
Handle, re-align the holes and reinstall the Pin Clip and Hitch Pin.
• The Eastwood Metal Bender is now ready for use.
FIG. 2
To order parts and supplies: 800.343.9353 >> eastwood.com
G.
Hitch Pin
B.
Ring Assembly/
Die Receiver
Handle
Extension
E
Handle/Die
Receiver
F.
J.
Handle
Hitch Pin
K.
Pin Clip
5