Setting Mixing Valve Close Time; Setting Burner Ignition Delay - Baxi MS THINK+ Installation Instructions Manual

REMOTE CONTROL UNIT
If a Remote Control unit is connected the parameter must be configured using the Remote Control unit. Access menu 2, as
described in section 5, and make the following settings:
PROGRAMME
VALUE TO SET
ROW
40
Room unit 1
LOW TEMPERATURE ZONE 2 CONFIGURATION
AMBIENT THERMOSTAT
If a room thermostat is connected the parameter must be configured using the Remote Control unit. Access menu 2, as described
in section 5, and make the following settings:
PROGRAMME
VALUE TO SET
ROW
6054 Room thermostat CH2
REMOTE CONTROL UNIT
If a Remote Control unit is connected the parameter must be configured using the Remote Control unit. Access menu 2, as
described in section 5, and make the following settings:
PROGRAMME
VALUE TO SET
ROW
40 Room unit 2

5.4 SETTING MIXING VALVE CLOSE TIME

Enter menu 2 from the control panel, as described in section 5, and make the following settings:
PROGRAMME
VALUE TO SET
ROW
834 Actuator stroke time
1134 Actuator stroke time
Change the default value from 30 seconds to 180 seconds.

5.5 SETTING BURNER IGNITION DELAY

If the low temperature safety thermostat trips, the burner ignition delay can be modified.
Enter menu 2 from the control panel, as described in section 5, and make the following settings:
PROGRAMME
VALUE TO SET
ROW
746 Heat demand delay
1046
Heat demand delay
1346 Heat demand delay
DESCRIPTION
Room sensor enabled in the remote control of low temperature zone 1
DESCRIPTION
H2 input enabled as low temperature zone 2 room thermostat
DESCRIPTION
Room sensor enabled in the remote control of low temperature zone 2
DESCRIPTION
Low temperature zone 1 mixing valve close time
Low temperature zone 2 mixing valve close time
DESCRIPTION
Low temperature zone 1 burner ignition delay
Low temperature zone 2 burner ignition delay
High temperature zone burner ignition delay
17 7222520.03 (1-11/15)