Assembly; Requirement For Assembly; Attaching Check Valve; Mounting Exhaust Hood - privileg SY-3388A2-P1-C81-L22-600 User Manual

Assembly

Requirement for assembly

You have read chapter page EN-4 and under-
stand all the safety notices.

Attaching check valve

(5)
Stifte
• Place the two halves of the check valve
(5) into the opening on the top of the
Exhaust hood(1).
Make sure that the pins on the valve are
facing outwards.

Mounting Exhaust hood

WARNING
Risk of injury!
Improper installation of the appliance
can lead to injury.
Before drilling the holes, ensure that
■
no wires or cables (power, gas, water
etc.) will be damaged (check with a
line locator).
CAUTION
Fire hazard!
The distance between the cooking
■
surfaces and the lower edge of the
Exhaust hood must be at least 65 cm
for gas stoves.
For gas stovetops, you must read the
■
user manual for the stovetop! If the
manual stipulates a larger distance,
this must be observed.
(5)
1. In order to place the appliance exactly
over the centre of the stovetop, first use
the pencil to draw a vertical guiding line
on the wall.
Ideally, use a level or a plumb bob from
the ceiling of the room to the middle of the
stovetop.
2. Hold the exhaust hood (1) to the wall so
the distance from the stove is at least 65
cm and the centre of the exhaust hood
aligns with the vertical guideline.
3. Mark the intersection point on the upper
edge of the exhaust hood.
4. Carefully set the exhaust hood to one
side.
Page EN-11
Assembly
guideline