Adjust Depth, Attach Docking Station If Desired; Adjust Side Bars To Limit Horizontal Movement; Adjust Monitor Arm Balance As Needed - Workrite Poise Installation Instructions

2

Adjust depth, attach docking station if desired

The depth of the laptop holder is adjustable. If a docking
a
station is to be used, attach the docking station to the
laptop before adjusting the depth of the laptop holder.
To adjust the depth, loosen the two knobs under the front
b
of the laptop holder, slide the tray to the desired depth and
tighten the knobs.
After adjusting the front plate, attach Velcro (D) to the
bottom of the docking station with laptop connected.
Remove adhesive backing and position into holder.
3

Adjust side bars to limit horizontal movement

a If a docking station is used it is recommended to not
use the side bars.
To adjust the side bars, loosen the rear clamp knobs
on each side. Slide the bars out and turn them so that
the rubber cap points up. Slide the rods in until they
contact the laptop. It may be necessary to move the
rods forward or back to allow clearance for USB ports
or other connections and drives. Once the rods are in
position, retighten the clamp knobs.
4

Adjust monitor arm balance as needed

a
Once installation is complete it may be necessary to adjust the balance of the monitor arm. See
the instructions supplied with the monitor arm for directions.
2 Workrite Ergonomics 800.959.9675 www.workriteergo.com
D