Workrite Poise Installation Instructions

Important Safety Instructions

Read and understand all these safety instructions before using the product.
During installation, beware of the recoil of the monitor arm body when attaching or detaching the laptop
!
holder to the monitor arm. To prevent damage or injury when changing the monitor arm configuration, always
raise the arm to its highest position before a monitor or laptop holder is detached.
Do not attempt to disassemble, service or modify the product.
Use only a slightly damp cloth to clean the monitor arm surface. Never use flammable solvents like alcohol, benzene,
thinner, etc. on the product.
A
Laptop Holder Assembly
Qty: 1
M8 Flat Head Cap Screw
Verify that you have all the hardware and tools needed for the assembly
Check your packages against the parts list above to verify that you have all the parts needed.
You will also need the following tool:
Pivot Pin
#2 tip Phillips screwdriver
1

Attach Laptop Holder to Monitor Arm

Insert 4 screws (B) through the top of the
a
Laptop Holder (A) and into the VESA plate
of a Poise or Willow arm. Secure with Keps
Nuts (C) with bolt facing down.
Willow /Poise
TM

List of Parts

B
M4 8mm Screw
Plastic Cap 7/32" Allen Wrench
Button Head Allen Cap Screw
Laptop Holder Installation Instructions
TM
C
#8 x 32 x ½ #8 x 32
Phillips Screws Keps Nuts
Qty: 4 Qty: 4
M4 16mm Screw
M4 12mm Screw
Plastic Pivot Washer Steel Washer
1/8" Allen Wrench
C
Velcro
Qty: 4
Spacer
a
®
B
A
C
#1500185 - Rev A