WELLSYSTEM RELAX Operating Instructions Manual page 14

Safety instructions and warnings
14/60
Assembly
DANGER!
Personal danger due to electric shock or burns!
– The assembly and electrical connection must comply
with the national regulations.
– The socket which is required for the electrical connec-
tion must be freely accessible or fitted with an easily
accessible all-pole isolating device (master switch),
complying with overvoltage category III. This means
that each pole must have a contact opening width com-
plying with the conditions of overvoltage category III for
full isolation
– Assembly, installation, upgrading or servicing of the
device may only be carried out by personnel specially
trained and authorized by JK-Global Service.
Information regarding the disassembly and assembly of the device is availa-
ble in the separate assembly instructions. These assembly instructions are
intended solely for use by the manufacturer's service personnel or by qualified
specialists authorized by the manufacturer.
Setup location
Overheating from inadequate cooling!
The device might be damaged!
– Maintain the minimum distances from the walls! Dimensions are given on
page 47.
– Do not change, obstruct or block the air inflow and outflow to the device or
make any unauthorized changes to the device.
Salty air! Contaminated air!
Device damage due to corrosion of the housing and electrical components.
– Do not install the device at swimming pools.
– Do not operate the device in locations with aggressive environmental
conditions (e.g. air containing chlorine).
Damage to the device possible!
Where there are great differences in temperature between the transport route
and the installation site the device may not be put into operation immediately
after being set up.
– Wait at least 2 hours before connecting the device to the power supply.
NOTICE!