Toro ProPass 200 Operator's Manual page 32

change. The next time you use the remote, the setting
will revert to the previously stored value.
Note:
A 10 second timer starts when you press
F S and FLRS (set-only mode) displays.
LOOR TART
If you do not press a button during the 10 second
interval, the display reverts to FLR and the previous
state/value displays and is enforced. The timer resets
to ten seconds if any button is pressed while the
remote is in the set-only.
1. Press the F
LOOR
The preview value and FLRS displays.
2. Adjust the speed setting using the I
F S button or the D
LOOR PEED
S button.
PEED
3. Press the F
LOOR
4. Press the F
LOOR
value.
The display shows FLOOR STORE. The set
value will be used whenever the floor is started
in the future until you change the setting again.
Setting and Operating the Option
Alone
Upon initially pressing the O
(when the option is not running), the remote
display shows the stored setting and an S is displayed
after OPT (i.e. OPTS), indicating that the remote is
in a set-only mode. In this set-only mode, you can
adjust the setting up or down, but the option does
not activate, remaining off. This allows you to set a
desired option speed or use the stored setting without
causing unwanted movement. After setting the speed,
press the O S
PTION TART
at the chosen setting (if the hydraulics are engaged,
the option will start). Press O
to store the current value in memory.
S button.
TART
NCREASE
F
ECREASE
or
S button to start the floor.
TART
S button to store the floor
TART
S button
PTION TART
button to activate the option
S a third time
PTION TART
Note:
Changes to the option settings while the
option is running are immediately effective, but they
are temporary unless you store the new setting by
pressing O
setting. For instance, you make an adjustment while
the display shows OPTS, press O
the option at the adjusted setting, and then turn the
remote off without pressing O
storing the change. The next time you use the remote,
the setting will revert to the previously stored value.
Note:
A 10 second timer starts when you press
O S
PTION TART
If you do not press a button during the 10 second
interval, the display reverts to FLR and the previous
state/value displays and is enforced. The timer resets
to ten seconds if any button is pressed while the
remote is in the set-only.
1. Press the O
LOOR
The preview value and FLRS displays.
2. Adjust the speed setting using the I
O
PTION
S
PEED
3. Press the O
option.
4. Press the O
option value.
The display shows OPTION STORE. The set
value will be used whenever the option is started
in the future until you change the setting again.
Setting and Operating the Floor
and Option Together
Upon initially pressing the A
(when the option is not running), the remote display
shows the floor and option stored settings and an S is
displayed after FLR and OPT (i.e. FLRS and OPTS),
32
S again after changing the
PTION TART
PTION
and FLRS (set-only mode) displays.
S button.
PTION TART
S button or the D
PEED
button.
or
S button to start the
PTION TART
S button to store the
PTION TART
S
LL TART
S starting
PTION TART
S again,
TART
NCREASE
O
ECREASE PTION
button