Toro ProPass 200 Operator's Manual page 22

Standard Hydraulics (Model 44701): Set the
hydraulic control to the dotted start line in the
corresponding color area
the speeds if required within the corresponding color
section.
Wireless Control (Model 44751): Set according to
the percentage indicated in the colored section of the
decal and on the chart on the back of the wireless
controller (Figure 37).
Adjusting the Slide
The slide adjustment positions the sand as it falls
onto the discs. The decal not only indicates the color
coded start position for each application, it illustrates
the adjustment required to fine tune your spread; refer
to Fine Tuning the Adjustments (page
(Figure 36). You can vary
Figure 36
Figure 37
22).
g013707
Note:
The colors on the decal shown in
correspond to the colors in the main operation decal
(Figure 28).
Adjusting the Floor Speed
The floor speed for every setting is usually 100%;
this was developed and tested in order to have 1
less factor to adjust in the Color-Coded Operating
System. Typically, you should use the tailgate to
reduce material volume, not the floor speed; however,
if the minimum tailgate height is insufficient to reduce
material flow, then decrease the floor speed.
decal119-6819
Fine Tuning the Adjustments
The color-coded operation system was developed to
take the guess work out of getting a perfect spread.
However, with so many variables such as sand weight,
granule size, moisture content, etc, your spread may
still be uneven.
22
Figure 38
Slide Decal Symbol
Figure 39
Figure 40
Floor Speed Decal Symbol
g013709
g013710
Figure 39
g013711