Toro ProPass 200 Operator's Manual page 21

Setting the Tailgate, Spinner
Speed, Slide, and Floor Speed
Once you have selected the desired spread and
ensured that the blades are properly adjusted, set the
rest of the machine adjustments.
Each setting is indicated on the machine by
corresponding color decals
Figure 32
If you want a light dusting, the blue area indicates that
your tailgate, floor speed, spinner speed, and base
slide adjustment should all be in their blue positions
(Figure 32).
LIGHT
Approximate Width: 9.1 m (30 ft)
Blade Position: A
Floor Speed: 100%
Spinner Speed: Blue/100%
Tailgate: Blue
Slide Adjustment: Blue
To fill aerification holes, adjust all settings to RED.
ULTRA HEAVY
Approximate Width: 2.7 m (9 ft)
Blade Position: B
Floor Speed: 100%
Spinner Speed: Red/15%
Tailgate: Red
Slide Adjustment: Red
Adjusting the Tailgate
The tailgate controls the volume of material that flows
from the ProPass (Figure
(Figure 32).
33).
The 5 inch tailgate is divided into colors with a target
starting line in each color section
increase or decrease the amount of material with the
tailgate as long as you stay within the corresponding
color section.
g013718
Note:
The colors on the decal shown in
correspond to the colors in the main operation decal
(Figure 28).
Adjusting the Spinner Speed
Note:
The colors on the decals shown in
and Figure 37 correspond to the colors in the main
operation decal
21
Figure 33
Tailgate Decal Symbol
(Figure
Figure 34
(Figure 28).
Figure 35
Spinner Decal Symbol
g013699
34). You can
g013705
Figure 34
Figure 36
g013706