Step 3. Verify That You Have the Correct Serial Cable
1
6
2
7
3
8
4
9
5
9 Pin DTE
© National Instruments Corporation
The correct serial cable you need depends upon which GPIB model you are
using. If you are using the GPIB-232CT-A, you must use a null-modem
serial cable (also known as an RS-232 DTE-to-DTE cable) to connect your
computer to the GPIB-232CT-A. If you are using the GPIB-485CT-A, you
must use a twisted pairs null-modem serial cable (also known as an RS-485
null modem cable) to connect your computer to the GPIB-485CT-A.
Table 2-3 lists the National Instruments cables that are null-modem serial
cables.
Table 2-3. National Instruments S and RS1 Null-Modem Serial Cables
National Instruments
Part Number
182238-01
182238-02
182238-04
181074-10
Figure 2-2 shows the pinout of the 9-pin to 9-pin National Instruments
S null-modem cables.
Figure 2-2. 9-Pin to 9-Pin Null-Modem Cable Pinout
Chapter 2
2-4
Configure and Install Your Hardware
Cable Type
9-pin to 9-pin, 1 m
9-pin to 9-pin, 2 m
9-pin to 9-pin, 4 m
9-pin to 25-pin, 1 m
5
9
4
8
3
7
2
6
1
9 Pin DTE
GPIB-232/485CT-A for Windows