Download Print this page
MSA ADVANTAGE 1000 Instructions For Use Manual

MSA ADVANTAGE 1000 Instructions For Use Manual

Cs/cn gas masks, twin-port, full mask facepiece respirator
Hide thumbs Also See for ADVANTAGE 1000:

Advertisement

CS/CN Gas Masks
Full Mask Facepiece Respirator
Instructions for Use
NIOSH approved for respiratory protection in atmospheres con-
taining CS/CN and particulates under the 42 CFR 84 P100 classifi-
cation (99.97% efficiency level) against all particulate aerosols,
including oil-based aerosols.
This manual, including the warnings and cautions inside, must
be read and followed carefully by all persons who use or main-
tain this product, including those who have any responsibility
involving its selection, application, service or repair. This respi-
rator will perform as designed only if used and maintained
according to the instructions. Otherwise, it could fail to perform
as designed, and persons who rely on this product could sustain
serious personal injury or death.
See separate insert for NIOSH Approval Information. (P/N 818082)
See inside for Instructions, Cautions and Limitations, and
Warnings. Please call 1-800-MSA-2222 during regular working
hours.
TAL 8001 (L) Rev. 10 © MSA 2008
WARNING
!
Prnt. Spec. 10000005389 (F) Mat. 814175
Doc. 814175

Advertisement

loading
Need help?

Need help?

Do you have a question about the ADVANTAGE 1000 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for MSA ADVANTAGE 1000

  • Page 1 See separate insert for NIOSH Approval Information. (P/N 818082) See inside for Instructions, Cautions and Limitations, and Warnings. Please call 1-800-MSA-2222 during regular working hours. TAL 8001 (L) Rev. 10 © MSA 2008 Prnt. Spec. 10000005389 (F) Mat. 814175 Doc. 814175...
  • Page 2: Table Of Contents

    TABLE OF CONTENTS NIOSH APPROVAL INFORMATION ....... . . 2 SPECIAL USER INSTRUCTIONS.
  • Page 3: Niosh Approval Information

    SCBA. For further information refer to MSA’s Response Respirator Selector. c. Replace canisters every shift or sooner, if indicated by change-out schedule or end-of-life indicator.
  • Page 4 Regulatory Agency with jurisdiction over the wearer). Additional OSHA Regulations may also apply for certain contami- nants (See MSA’s Response Respirator Selector). 7. Do not use canister(s) after expiration date on label. RESPIRATOR USE LIMITATIONS IN CBA (CHEMICAL - BIOLOGICAL...
  • Page 5: General Description

    be using and have a tested fit factor of 1000 or greater. 3. It is recommended that each user should be outfitted with a facepiece with CBA canister, a hood, and full chemical protective suit including gloves and shoe coverings. 4.
  • Page 6: Preparations For Use

    RESPIRATOR FIT TEST A qualitative or quantitative respirator fit test must be carried out for each wear- er of this respirator to determine the amount of protection it will provide. Respirator fit tests are explained fully in the merican National Standard for Respiratory Protection, ANSI Z88.2, which is published by the American National Standards Institute.
  • Page 7: Donning The Respirator

    Plug. The Inlet Cap Plug must seal to the facepiece. Seal the cap onto the face- piece by turning the cap clockwise onto the connector to stops. DONNING THE RESPIRATOR DONNING THE ADVANTAGE 1000 RESPIRATOR GASK MASK AND ADVANTAGE 3200 WITH RUBBER HARNESS 1. Loosen the adjustable harness straps. Grip the straps by inserting thumbs through the straps.
  • Page 8 3. If necessary, adjust the mask and tighten harness by pulling loop on the back of harness. Donning Procedure B 1. Completely loosen the two bottom straps, insert fingers and hold the loop on the back of the harness. 2. Place chin into the mask. 3.
  • Page 9: Cleaning And Disinfecting

    CLEANING AND DISINFECTING The facepiece assembly (with canister removed) should be cleaned and disin- fected after each use. MSA recommends using Confidence Plus™ Cleaning Solution. Refer to the label of the cleaning solution for use instructions. A solu- tion as effective as Confidence Plus™ Cleaning Solution and compatible with MSA respirator components may be substituted.
  • Page 10 The wax affords the rubber the required protection it needs during expected product use. It is normal for this wax to come to the surface and can be cleaned by using MSA Confidence Plus (P/N 10009971). Rubber surface imperfections may be observed upon closer inspection of the mask and are typically caused by the white wax residue.
  • Page 11 TAL 8001 (L) Rev. 10 - 814175...
  • Page 12 TAL 8001 (L) Rev. 10 - 814175...

This manual is also suitable for:

Advantage 3200Advantage 3000