Advertisement
4
1
2
3
To Connect the Tubing to a Fitting:
1.
Remove the lock if present (not present
in self-locking fittings).
2.
Push. Insert the tube firmly until full stop.
3.
Pull the collet back slightly.
4.
Replace the lock (if present).
Placement Guide:
Remember this unit must be serviced at regular intervals. Therefore it should be reasonably
accessible (for changing filters, etc.).
6
No skewed cut!
IMPORTANT: Cut Tubing At 90º to Ensure a
Watertight Seal:
4
1
3
2
To Disconnect the Tubing:
1.
Remove the lock if present (not present
in self-locking fittings).
2.
Push the collet and hold.
3.
Pull the tubing out.
4.
Replace the lock (if present).
Advertisement
