take new filter and install it in the place of the removed one observing the water flow direction
■
arrow on its label and restoring the connections (see the internal connections chart for details)
close the cover, reconnect the external tubes and place the unit back in its place
■
After you finished changing filters follow the „initial washing" procedure described above.
With initial operation, check for leaks. If a leak is observed, verify that the tube or branch pipe
of the filter housing is pushed into the quick fitting far enough to seal the tube against the
O-ring and that the tubing was cut at 90º.
Filtration Unit Internal Connections Chart
inlet
to the faucet
11