Sony Vision Exchange PEQ-C100 System Integration & Services Manual page 96

Note
If the Home page of Vision Exchange appears without displaying the password entry
screen, turn the unit off, and then follow the procedure again from step 2.
To turn the unit off, press
dialog box, and press [OK].
9. Enter "sonypsg" on the password entry screen.
10. Read the terms on the License Agreement screen, and press the [OK] button.
Restoration to factory default status begins. This process takes approximately 20 minutes.
The unit turns off automatically when the process is finished.
11. Press the power button on the unit to turn it on.
12. Press the "c" key on the keyboard when the following message appears.
The unit reboots.
Note
If you do not press the "c" key, the unit will automatically reboot after a set period has
elapsed.
12-1. If this occurs, press the [Accept] button when the EULA screen is displayed after
rebooting.
12-2. Press the [OK] button on the setup screen.
The unit reboots.
13. After booting, check that the Home screen of Vision Exchange is displayed, then turn the
unit off.
To turn the unit off, press
dialog box, and press [OK].
14. Press the power button on the unit to turn it on.
15. Repeat steps 2 to 4 to display the BIOS screen.
16. Check that "Boot Option #1" in the [Boot] menu is set to "Windows Boot Manager." If it
isn't, reset it to "Windows Boot Manager."
in the bottom right of the screen to display the [Shut down]
in the bottom right of the screen to display the [Shut down]
96