Gecko in.k800 Quick Reference Card

Please consult your spa user manual for complete info on the features of your spa system.

Description

Settings
Key 2
Mode
(optional)

Main functions

Settings key
One press gives you access to a menu to manage the
settings of your spa. Refer to the settings section for
details about the settings menu.
Mode key
Successive presses on the Mode key will give access
to control different optional accessories of your spa
such as Audio and others. Note that if an accessory
is not present in your spa configuration, its menu will
not appear. Refer to the following section to get details
About the possible accessories and their detailed
functionalities. The screen will revert back to the spa
mode if no key is pressed for 60 seconds.
Power
Press any button to turn the keypad on.
After 30 minutes without activity it will shut off.
8
Quick Reference Card
in.k800
intuitive color keypad
With its bright, full color display, the in.k800 provides an intuitive
user experience, while its screen's high resolution brings hot tub user
interfaces to a new level. Loaded with a large amount of memory and
a powerful on-board processor we have created the seamless
graphic interface that spa users have been waiting for.
Key 1
Key 3 Selection lights
Main screen
The main screen gives you access to your accessories
and water temperature. At the bottom of the screen
you will see any error or maintenance messages that
are present.
Notifications
A notification area at the top right-hand side of the
screen shows the state of certain accessories installed
in the spa.
In.mix:
• Indicates that an in.mix system is detected.
In.clear:
• The icon is green when the in.clear is
generating bromine.
• The icon is grey when the in.clear isn't
generating bromine.
• A red cross indicates that the in.clear
is turned off.
in.touch:
• Indicates that the in.touch module is
detected and connected to a Wi-Fi network.
• A red cross indicates that the in.touch
module is detected but isn't connected
to a Wi-Fi network.
in.steam 2:
• The icon is green when the in.stream 2 is ON.
• The icon is grey when the in.stream 2 is OFF.
For more information about the in.mix, in.clear,
in.touch or in.stream 2, refer to the Techbook.
Key 4
* Functions for keys 1 to 5 will depend on
your system's low level configuration.
Light/ Key 6
Start or stop accessories
To start or stop an accessory, press the associated
button. Icons will become animated when their
accessory is turned on, and inanimate when turned
off. Icons on the screen will reflect the speed
or state of the devices running on your spa.
When an accessory has more than two states,
press the button until it reaches the desired state.
Water temperature
The temperature shown at the bottom of the screen
gives the actual water temperature. Use the Up and
Down buttons to set the desired temperature.
The set point will appear in blue. After 3 seconds
without any change to the set temperature value,
the current water temperature will reappear.
Up
Key 5
Down