Table of Contents
Advertisement
Mounting the Camera
1. Use the ¼"-20 UNC threaded holes to mount the camera on to a bracket, tripod or in an enclosure as
required.
Mount the camera using the tripod collar on the lens.
o
If the lens does not have a tripod collar, use the threaded hole at the bottom of the camera.
o
Consult the installation instructions provided with the bracket, tripod or enclosure for detailed mounting
instructions.
CAUTION — Always mount the camera from the lens tripod collar when the lens includes a collar.
The camera shall be mounted horizontally or with the lens pointed downwards.
WARNING — Use only UL-listed mounting bracket suitable for the mounting surface and minimum
0.4 kg (0.9 lb) weight plus the weight of the attached lens.
Connecting Cables
Refer to the diagrams in the Overview section for the location of the different connectors.
To connect the cables required for proper operation, complete the following:
1. If external input or output devices are part of the installation (for example: door contacts, relays, etc.),
connect the devices to the I/O connector block.
2. If an external microphone or speaker is required, connect the devices to the audio connector.
3. Connect power using one of the following methods:
Power over Ethernet (PoE) Class 3 — If PoE is available, the LEDs will turn on.
o
External Power — Connect an external 12 V DC or 24 V AC power source to the power
o
connector block.
Note: The lens must be mounted before you power the camera.
4. Connect a network cable to the Ethernet port (RJ-45 connector).
The Link LED indicator will turn on once a network link has been established.
5. Check that the Connection Status LED indicator indicates the correct state. For more information, see
Connection Status LED Indicator on
Initializing a Camera Username and Password
Cameras manufactured after January 1, 2020, do not have a default username or password and will be in a
factory default state.
Mounting the Camera
page 13.
6
Advertisement
Table of Contents
