Transaction Entries; When An Error Has Occurred; Displaying The Time - TEC MA-156-1 SERIES Owner's Manual

12. Transaction Entries

If the register is programmed with all requirements, it is ready
to accept transaction entries. Before starting to enter transac-
tions, set the Mode Select Switch to the REG position.
When opening the cash drawer, be careful not to let the drawer hit any person.

When an error has occurred...

When the buzzer sounds continuously and "E" is indicated in the leftmost digit of the display,
the last operation has caused an error and the keyboard is locked. In that case:
Press the
C
This function of the [C] key is also applied to operations in other Mode Select Switch
positions.
If errors occur repeatedly on operating the same key sequence, check the cause of the
error. The following are possible causes of error:
The Mode Select Switch position is wrong.
The numeric value entered exceeds the high amount limit.
A numeric value has not been entered where required.
A numeric value has been entered where prohibited.
The key sequence is wrong, or a wrong key has been pressed.
The operation is not allowed at the current timing.

Displaying the Time

The time can be displayed on the register any time when the register is outside a sale.
X/TIME
........... Displays the current time.
The time display will disappear when any key excluding the [FEED] key is pressed on the
keyboard or the Mode Select Switch position is changed.
key to cancel the error condition and the keyboard is now operable.
WARNING!
hour minute
- 26 -
EO1-11099
SET
OFF
REG
X
Z