Siemens SIMATIC IFP2200 Operating Instructions Manual page 48

Installing and connecting the device
3.3 Mounting the PRO device
1. If an adapter plate for the Siemens base
adapter is included in your support arm
system, attach the adapter plate to the
support arm with 4 M6x12 screws.
Pay attention to the torque that is specified
for the support arm.
2. Attach the base adapter with
4 M6x12 screws to the mechanical
interface of the support arm from below.
Pay attention to the torque that is specified
for the support arm.
3. Loosen the 8 screws of the backplane cover
and remove the backplane cover.
4. Insert all connection cables through the
opening of the PRO device.
Make sure that the connection cables are
not damaged.
5. Attach the device with 4 M4x12 screws to
the base adapter from the top, torque 2.5 Nm.
Make sure that the connection cables are not
crushed.
6. Connect all cables according to the description in the section below.
7. Fasten the backplane cover to the device with the 8 screws, torque 1.5 Nm. Check that the seal is sitting
correctly.
48
Industrial Flat Panel IFP1500, IFP1900, IFP2200, IFP1900 PRO, IFP2200 PRO, IFP1900 ETH, IFP2200 ETH
Operating Instructions, 07/2016, A5E31298376-AF