Heater Control Panel - Ecostrad GH-20F-APP Instruction Manual

Heater Control Panel

•
Turn the heater on at the side switch. The heater will beep as it switches on. The
heater starts on standby mode, displaying the
temperature of the room in
•
To initiate heating, press the
the low power icon.
•
To change heating mode, press the
low power
heater at full power when the temperature drops below 5°).
To adjust the set temperature of the heater, use the
•
power or full power
The set temperature is the same for both modes. The low power mode just
uses a single 1kw element to achieve the temperature, while the high power
mode uses both elements for a 2kw output.
•
Frost protection mode is set to 8 °C. This cannot be changed.
•
To set the timer, press the
Press repeatedly to adjust the required working time. Timer range is 1 – 24
hours. The digits will flash while setting and then the screen will return to heating
mode. The timer icon
heater will heat until the time has elapsed.
•
To schedule your heater to switch on later, press the
standby mode. Press
hours. The digits will flash while setting and then the screen will return to heating
mode. The timer icon
heater will switch on when the delay has elapsed.
•
To set the child lock, press and hold the
will appear on the screen and the control panel will be locked out. To release,
press and hold the
all the buttons can be used again.
.
. This means the device is in the 1kw low power state.
(1kw), full power
mode, you can set the temperature from 15 - 50 C°
button while the heater is in heating mode.
on the screen will show that the timer has been set. The
repeatedly to adjust the delay. Delay range is 1 – 24
on the screen will show that the timer has been set. The
button. The padlock icon
WiFi icon and the current
button. You will see the heating icon
button to cycle through the modes:
(2kw), and anti-frost mode
and
buttons. The padlock icon
will disappear, indicating that
and
(activates
and buttons. In low
button while on