Removing The Appliance; Conversion To Another Type Of Gas - Gaggenau VG 231 CA Installation Instructions Manual

Removing the appliance

Disconnect the appliance from the power and the gas
supply. Push out the appliance from below.
9
CAUTION
Risk of damage! Do not lever out the appliance
from above.

Conversion to another type of gas

This gas stovetop corresponds to the categories
specified on the rating plate. By changing nozzles, it is
possible to convert the appliance to any of the gases
listed on the plate. The conversion kit is included in the
scope of delivery.
Only a licensed specialist is authorized to switch the
appliance to another gas type.
Before carrying out the conversion, turn off the
electricity and gas supply.
Changing the low burn nozzle:
1 Remove pan support and all burner parts.
2 Unscrew two fastening screws (Torx T20) and
remove stovetop.
3 Remove control knob. Remove control panel:
Unscrew the two upper, lateral fastening screws
(Torx T20). Raise control panel in the rear and push
it forward. Remove switch cover.
4 The low burn nozzle is located in the gas valve and
is screwed in from above. For easier accessibility,
turn switch or remove securing ring and remove
switch. Unscrew the nozzle and insert the new
nozzle as specified in the low-setting nozzle table.
The nozzle must be screwed in fully.
5 Put switch, securing ring, switch cover and control
panel back in place and screw them tight. Put on
control knob.
Changing the full burn nozzle:
1 Remove securing clips on the burner pipes.
Remove burner pipes. Loosen screw on air-
regulating tube. Remove nozzle fitting.
2 Remove nozzle and O-ring for inner circular burner
by hand. Unscrew nozzle for outer circular burner
(SW10).
11