Lcd Display Information; Battery Charge Level/Low Battery Indication; Charging Rechargeable Batteries; Using The Twintalker 1300 - Topcom Twintalker 1300 User Manual

TOPCOM TWINTALKER 1300
9

LCD DISPLAY INFORMATION

10

BATTERY CHARGE LEVEL/LOW BATTERY INDICATION

The BATTERY CHARGE LEVEL is indicated by the number of squares present inside the BATTERY icon on the LCD
Screen.
SC
TX RX
When the BATTERY CHARGE LEVEL is low, the BATTERY icon will flash to indicate that the batteries need to be
replaced or recharged.
11

CHARGING RECHARGEABLE BATTERIES

The PMR can be used with 4 alcaline or rechargeable NiMh AAA batteries (no batteries included).
Only use the optional AC/DC ADAPTER (not included) with "AAA" rechargeable batteries
(No batteries and adapter included). Do not try to charge this unit when regular "AAA"
alkaline batteries are installed.
When using rechargeable batteries you can use the optional adapter to charge.
• Insert four (4) "AAA" rechargeable batteries (not included).
• Plug the small plug of the 7,5 V DC / 200 mA adapter into the SPK/MIC/CHG jack (3) and the
other end in the electrical socket.
• Make sure that the unit is switched off in order to charge the batteries properly. There is no
charge indicator during charging at OFF mode.
NOTE: It takes approximately 7 to 10 hours to fully charge the batteries.
12

USING THE TWINTALKER 1300

12.1 TURNING THE UNIT ON/OFF
• To activate; press and hold
• To switch off; press and hold
6
a. Channel number
b. Speaker Volume
c. RX icon - Displayed when receiving a signal
d. TX icon - Displayed when transmitting a signal
e. Lock icon - Displayed when the keypad is locked.
f. Battery charge level indicator
g. Scan icon - Displayed when scan mode is active
Battery Full
Battery 2/3 charged
Battery 1/3 charged
Battery empty
Dispose of batteries at a designated battery disposal unit and
not in the household waste. Do not short-circuit & dispose of in
fire. Remove the batteries if this device is not going to be used
for a long period.
. The unit will "beep" and the LCD Screen will display the current channel.
again. The unit will "beep" and the LCD Screen will turn blank.
TOPCOM TWINTALKER 1300