SoundTube RS31-EZ-T Install Instructions

Download this manual

RS31-EZ(-T)

Box contents

1 Speaker assembly

2 Mounting screws

2 Wire Nuts

Safety leash

Warning

SoundTube speakers must be installed by a professional audio installer/contractor. For safety and for

optimum audio performance, installer must follow all directions issued by SoundTube Entertainment.

Install Instructions For:

RS31-EZ(-T)

Junction Box (not included)

Minimum internal depth: 1.5 inch (38.1 mm)

Mounting plate

(shown with transformer)

Adjustment loop

Mounting screws (2)

Cover plate

Speaker

1.435.647.9555

Warning

Do not spec or install speaker near support beam, ventilation duct or

other structure that may interfere with speaker function or dispersion.

800.647.TUBE

www.soundtube.com

Do you have a question about the RS31-EZ-T and is the answer not in the manual?

Page 1: Box Contents
Warning Warning SoundTube speakers must be installed by a professional audio installer/contractor. For safety and for Do not spec or install speaker near support beam, ventilation duct or optimum audio performance, installer must follow all directions issued by SoundTube Entertainment.
Page 2 5. Connect Signal wire into 8. Move cover plate up 7. Set speaker height by 6. RS31-EZ-T wiring: terminal block adjusting speaker wire. speaker wire, begin to Connect the negative Push wire through the thread cover plate into signal wire to “com”...
Page 3 RS31-EZ(-T) Install Instructions For 8 Ohm Bypass 3. Un-land the red and 4. Refer to steps 8-11 on 2. Remove the input 1. Remove speaker from page 2 to complete module mounted onto the black wires from the box and unscrew the cover installation.

Rs31-ez