Handling Notes - Denso BHT-202Q-CE Operator's Manual

36
• An early upload of gathered data is recommended, since the data stored in the
RAM might be affected by the so-called "soft error" or other environmental
phenomena. In some cases, the "Contact your administrator." will appear on the
LCD.
• Do not use the BHT in the vicinity of radio equipment. The BHT may malfunction.
• Avoid storing the battery cartridge in a hot place. The battery capacity may be
decreased.
• Do not touch the battery cartridge terminals or BHT's charge terminals by hand or
stain them. Doing so could result in BHT's malfunction or cartridge charging
failure.
• When connecting or disconnecting cables, do not plug or unplug at an angle and
do not pull them strongly. Doing so will result in a machine failure.
• If the BHT has been stored in a hot (50°C to 60°C, 122°F to 140°F) and humid
place, allow it to sit at room temperature and humidity for at least one day before
use. Using the BHT with its inside being hot will fail to scan or result in a machine
failure.
• If the stylus wears so that its tip becomes sharpened, replace it.
• In environments where static electricity can build into significant charges, do not
operate the BHT. Doing so will result in malfunction or machine failure.
• Avoid dropping the BHT or letting it undergo any shock or impact. Doing so will
break or damage the BHT.
• If the "Replace the batteries!" or "Charge the battery!" message appears after the
BHT undergoes any shock or impact, turn the BHT off and on and then check the
battery output level. The battery may not have run out.
• Battery cartridges should be recycled properly in conformity with local codes and
regulations.

Handling Notes