Table of Contents
Advertisement
PROGRAMMING PROCEDURES
1. Set time of day:
Time of day should only need to be set after extended power outages or when daylight saving time begins or ends .
If an extended power outage occurs, the time of day will flash on and off indicating that the time should be reset .
STEP 1 – Press
STEP 2 – CURRENT TIME (HOUR): Set the hour of the day using + or — buttons . AM/PM toggles after 12 .
Press
STEP 3 – CURRENT TIME (MINUTES): Set the minutes using + or — buttons . If it is desired to back up to
the previous step press
operating display (page 10) .
1
2. Programming:
NOTE: The manufacturer has preset the unit so that the gallons between regenerations
will be automatically calculated .
STEP 1 – Press
STEP 2 – HARDNESS: Set the amount of hardness in grains per gallon
(default 20) using the + or — buttons . The allowable range is
from 1 to 150 in 1 grain increments .
Press
STEP 3 – DAY OVERRIDE: The manufacturer has factory set 14 DAYS as the
default . This is the maximum number of days between regenerations .
If this is set to "OFF", regeneration initiation is based solely on
gallons used . If any number is set (allowable range from 1 to 28), a
regeneration initiation will be called for on that day even if a sufficient
number of gallons were not used to call for a regeneration .
Set Day Override using + or — buttons (3 is recommended):
Press
previous step .
STEP 4 – REGENERATION HOUR: The manufacturer has factory set 12:00 A .M .
as the default . This is the hour of day for regeneration and can be reset
by using + or — buttons . "AM/PM" toggles after 12 . The default time is
12:00 a .m . (recommended for a normal household) .
Press
previous step .
STEP 5 – REGENERATION MINUTES: Set the minutes using + or — buttons .
Press
to return to the previous step . To initiate an immediate manual
regeneration, press and hold the
The system will begin to regenerate immediately . The control may be
manually stepped through the regeneration cycles by pressing
STEP 6 – BACKLIGHT DISPLAY CONTROL (Not available on all models):
Set the display backlight on or off using + or — buttons . In the OFF
position, the backlight will turn off after 5 minutes of inactivity .
.
set clock
to go to step 3 .
next
button once . Pressing
regen
2
and + simultaneously for 3 seconds .
next
to go to step 3 . Press
next
• set number of days between regeneration (1 to 28); or
• set to "OFF" .
to go to step 4 . Press
next
to go to step 5 . Press
next
to exit installer programming . Press
next
will exit
next
3
to exit .
regen
if you need to return to the
regen
if you need to return to the
regen
if you need
regen
button for three seconds .
regen
9
and return to the general
set clock
1
2
3
4
5
6
.
regen
Advertisement
Table of Contents
