Table of Contents
Advertisement
9 . SAFETY BRINE TANK CONNECTION: Install the 3/8" O .D . polyethylene tube from the Refill Elbow to the
Brine Safety Float valve in the brine tank .
Connection at Refill Elbow on the control valve
10 . OVERFLOW LINE CONNECTION: An overflow drain line is recommended where a brine overflow could
damage furnishings or the building structure. Your softener is equipped with a brine tank safety float which
greatly reduces the chance of an accidental brine overflow . In the event of a malfunction, however, an overflow
line connection will direct the "overflow" to the drain instead of spilling on the floor where it could cause
considerable damage . This fitting is an elbow on the side of the brine tank . Attach a length of 1/2" I .D . tubing
to fitting and run to drain . Do not elevate overflow line higher than 3" below bottom of overflow fitting . Do not
"tie" this tube into the drain line of the control valve . Overflow line must be a direct, separate line from overflow
fitting to drain, sewer, or tub . Allow an air gap as per the drain line instructions .
Connection at Brine Safety Float in brine tank
7
Advertisement
Table of Contents
