Table of Contents
Advertisement
PRE-INSTALLATION INSTRUCTIONS FOR DEALERS
The manufacturer has preset the water treatment unit's sequence of cycles and cycle times .
The dealer should read this page and guide the installer regarding hardness, day override, and time of regeneration,
before installation.
For the installer, the following must be used:
• Program Installer Settings: Day Override (preset to 3 days) and Time of Regeneration (preset to 12 a .m .)
• Read Normal Operating Displays
• Set Time of Day
• Read Power Loss & Error Display
For the homeowner, please read sections on Bypass Valve and Operating Displays and Maintenance .
During operation, the normal user display is time of day and gallons per minute .
Flow Rate, Capacity Remaining and Days to a Regeneration are optional displays but are not normally used . Each of
these can be viewed by pressing
are pressed within 5 minutes, the display returns to a normal user display . Any changes made prior to the 5 minute
time out are incorporated . To quickly exit any Programming, Installer Settings, etc ., press
made prior to the exit are incorporated .
If desired, two regenerations within 24 hours are possible with a return to the preset program .
To do a double regeneration:
1 . Press the
regen
2 . Press and hold the
Once the valve has completed the immediate regeneration, the valve will regenerate one more time at the preset .
to scroll through them . When stepping through any programming, if no buttons
next
button once . "REGEN TODAY" will flash on the display .
button for three seconds until a regeneration begins .
regen
3
. Any changes
set clock
Advertisement
Table of Contents
