Using Features Of Lip Phone 6812; Receiving A Call; Placing A Call; Putting A Call On Hold - LG NORTEL 6812 User Manual

3. Using Features of LIP Phone 6812

3.1. Receiving a Call

When you receive a call, your phone rings, the LCD displays the incoming call information and the
associated line button flashes.
To answer a ringing call:
o Lift the handset. You may press the speakerphone button, line button or the
activate the speakerphone. To use a headset, press the headset button.
To end the call:
o Hang up the handset. If using the speakerphone, press the speakerphone button. If using the
headset, press the headset button.
To refuse a ringing call:
[Refu]
o Press softkey, the LIP Phone stops ringing and the call server routes the call.

3.2. Placing a Call

You place calls with the handset on-hook or off-hook. Similar to your mobile phone, LIP Phone 6812
uses a technique called 'store and forward dialing'. After you dial a digit, the LIP Phone waits about 10
seconds for additional digits. If you do not dial additional digits, the LIP Phone sends the digits you dialed
to the call server for processing. To send the digits immediately, press the # button to indicate dialing is
complete, and then the LIP Phone sends the number to the call server.
To place a call:
o Lift the handset. You may press the speakerphone button or line button to activate the
speakerphone. To use a headset, press the headset button.
o Dial the destination number. After a short delay, the LIP Phone sends the number, or dial # to
send the dialed digits immediately.
o When the called party answers, begin speaking, the LCD displays the elapsed call time.
To end the call,
o Hang up the handset. If using the speakerphone, press the speakerphone button. If using the
headset, press the headset button.

3.3. Putting a Call on Hold

You can place a call in a waiting state where the held party cannot hear you and you cannot hear the held
party. The held party receives MOH (Music On Hold), if configured in the call server.
While a call is on hold, you can answer or place other calls and can toggle between held calls on the
same line by pressing the line button. With Call Hold Ringback enabled, the LIP Phone rings as a
reminder of calls on hold when you return the LIP Phone to idle. Refer to your system administrator or
Installer Guide for further information.
To place a call on hold:
[Hold]
o Press the
then select another line to answer or place a call. Note, if you select an idle line and take no
action for about 10 seconds, the line is disconnected.
To retrieve a held call:
softkey. The call status changes to hold and you receive dial tone. You may
4
LIP Phone 6812
User Guide
[Answ]
softkey to
Oct. 07