Insignia NS-TWM16WH9 User Manual page 26

Open the lid of the washer, then pour water into the tub to the leveling circle.
2
If the washer is level the water will touch the leveling circle all the way around.
If the washer is not level, the water will only touch part of the leveling circle.
Add water to the washer until it reaches
the leveling circle. If the washer is level, the
water will touch the leveling circle all the
way around. If it's not level, it will only
touch part of the leveling circle.
If your washer is not level, carefully tilt your washer just enough to adjust the
3
leveling foot on the bottom left of your washer. Extend the foot only as much
as is necessary. If the foot is extended too much, your washer may vibrate.
Step 7: Power your washer
26
Leveling circle
Level
Lock
Loosen
Plug the power cord into a well-grounded, 3-prong,
120 Volt 60Hz approved electrical outlet, protected by
a 15-amp fuse or comparable circuit breaker. Your
washer is grounded through the third prong of the
power cord.
www.insigniaproducts.com
Washer is level - the water Washer not level - the water
touches the leveling circle
all the way around.
NS-TWM16WH9
does not touch the leveling
circle all the way around.