Battery Status; Operating Time; Using Icube With A Client - Unitron iCube Complete Manual

Battery status

While turned ON, your iCube indicates the battery status on
the battery indicator LED as follows:
• Yellow, slow flash – Battery level is high.
• Yellow, fast flash – Battery level is low.
Once the fast flashing starts, your iCube will still operate for
about an hour, but you should recharge the battery as soon
as possible.
The current battery status is also displayed in the software:
• In TrueFit, in the expanded Connections tab of the Quick
View Pane
• In U:fit, in the iCube Configuration dialog
For safety reasons, recharge the battery only with chargers
supplied by Unitron.
During the charging process, the battery indicator is lit solid.
Once the battery is fully charged, the battery indicator will
start flashing slowly. Normally, charging an empty battery
takes about 90 minutes. It is safe to leave the charger
connected overnight – the battery cannot be overcharged.
6

Operating time

Fully charged, your iCube will operate for up to four hours in
normal use.
Battery consumption and the operating time of the iCube
greatly depend on the usage of the device. Heavy use will
reduce the operating time of your iCube between battery
recharges.

Using iCube with a client

Batteries need to be inserted into the hearing aids and the
hearing aids need to be turned on prior to detection.
Before using iCube to fit a client with
hearing aids, make sure the battery is
sufficiently charged. Unplug the charging
cable from the iCube and turn it ON.
Wearing iCube
Open the neckloop by unplugging the
jack, and place iCube around your
client's neck as shown. (Re)connecting
the neckloop will activate the built-in
antenna and enable iCube to operate
correctly.