First Time Setup; Connecting Icube To Your Computer - Unitron iCube Complete Manual

First time setup

Charging the iCube prior to setup
Connect the iCube charger by plugging the power supply
into a power outlet and the mini USB plug into the iCube as
shown below. Alternatively you can charge your iCube with
the USB cable using the USB port on your computer system.
Your iCube battery can be charged hundreds of times. If the
operating time of your iCube reduces substantially, please
contact your local Unitron representative.
Prior to the first use, ensure that the iCube battery is fully
charged.
Note: When charging your iCube for the first time, leave it to
charge for at least three hours (even if the battery indicator
starts flashing earlier).
Turning iCube on/off
To turn ON your iCube, press and hold the ON/OFF button for
about a second until you see the battery indicator turn ON.
Once your iCube is fully operational, the battery indicator will
flash slowly.
To turn OFF your iCube, press and hold the ON/OFF button
for about two seconds until you see the battery indicator turn
ON. Release the ON/OFF button. Once you release the ON/
OFF button, the battery indicator will go dark and your iCube
is OFF.

Connecting iCube to your computer

iCube allows you to wirelessly program hearing instruments
via a Bluetooth connection.
Alternatively it can be used with a wired USB connection for
places where Bluetooth connections are not allowed.
In either case, before you can start using your iCube, it needs
to be connected with your computer.
Connecting via Bluetooth
Connecting your iCube via Bluetooth is done in three steps:
3