Using Icube Without A Client; Detecting And Programming Hearing Instruments; Reset Button; Important Information - Unitron iCube Complete Manual

Using iCube without
a client
When programming hearing
instruments without having your
clients wear them, make sure they
are turned on, and are in range of the
iCube. Please note that they are best
positioned inside the loop.
Detecting and programming hearing
instruments
In wireless fittings, it is necessary to tell the software which
hearing instrument is the left and which is the right. Click the
Detect button on the detection screen. A window appears
showing the detected hearing instruments.
Assign (or reassign) each hearing instrument to the desired
side (left or right). You can play a beep identification to
confirm that left and right have been selected properly.
Continue as usual with the fitting.
During the programming of hearing instruments, the right
side and the left side fitting indicator flash fast red, and blue,
respectively.

Reset button

If, for some reason, iCube becomes
unresponsive, remove the cover by
sliding it upwards. Press the reset button.
The Bluetooth pairing will not be lost.
If all three indicators on your iCube are
lit solid, this may indicate a software
problem. Refer to Troubleshooting
iCube
section.

Important information

Maintenance and care
• Clean iCube using a damp cloth. Never use household
cleaning products or alcohol to clean the device.
• Protect iCube from excessive moisture, heat, excessive
shock and vibration.
• When iCube is not in use, turn it OFF and recharge it so it
will be sufficiently charged and ready for the next fitting
session.
Safety notice and other important information
• Keep this device out of reach of children under 3 years.
11