Icube System Configuration Options - Unitron iCube Complete Manual

Removing a Bluetooth pairing
If you wish to delete the Bluetooth pairing
from your iCube, press and hold the
Bluetooth pairing button for about 10
seconds until the Bluetooth indicator is lit
solid blue.
Connecting via USB cable
1. To connect your iCube via USB cable instead of
Bluetooth open the iCube Configuration window:
• In TrueFit, select Options > iCube Configuration
• In U:fit, select Options > iCube
2. Connect your iCube via the USB cable to your
computer.
Note: When connecting iCube for the first time via USB, your
computer will start searching for the associated driver
software. Depending on the operating system, you may be
presented with an installation wizard: Found New Hardware
Wizard. If so, let your computer automatically install the
necessary driver software. The driver software has already
been installed during the fitting software installation and
should be identified by the wizard. It is not necessary to insert
the installation CD.
3. To allow the fitting software to use the connected
iCube:
• In TrueFit, select Check in the iCube connected via USB
box
• In U:fit, select Detect in the USB connected iCube dialog
box
Upon successful detection the serial number of the
connected iCube is displayed.

iCube system configuration options

Start the iCube pairing wizard:
• In TrueFit, select Options > iCube Configuration
• In U:fit, select Options > iCube
To remove a listed iCube, click Remove iCube.
In cases where multiple iCubes are paired with a computer,
you can choose the default iCube by selecting the iCube with
the desired serial number. The asterisk indicates which iCube
is currently being used as the default.
5