Table of Contents
Advertisement
1.3 Safety instructions
This section describes safety precautions, which must be observed when installing and operating a product from
Barco.
1.3.1 Precautions
For your own protection, observe the following safety precautions when installing,
operating and servicing your device:
•
Before operating the units please read this manual thoroughly and retain it for future reference!
•
Observe all warnings and instructions printed on the devices!
•
Servicing not explicitly mentioned in this manual should never be carried out by unauthorized personnel!
Never open the case of the unit without first disconnecting both power supply cords!
•
The appliance couplers on this unit must be used for disconnecting the unit from the mains circuit. For
removal of all power from the unit, always disconnect both supply cords.
•
To prevent fire or electrical shock hazard, do not expose this unit to rain or moisture!
•
This product should be operated from an AC power source!
•
Check that the voltage and frequency of your power supply match those printed on the device label with the
rated electrical values!
•
If you are not sure of the type of AC power available, consult your dealer or local power company!
•
This product is equipped with a 3-wire grounding plug, a plug having a third (grounding) pin. This plug will
only fit into a grounding-type power outlet. This is a safety feature. If you are unable to insert the plug into
the outlet, contact your electrician to replace your obsolete outlet. Do not defeat the purpose of the
grounding-type plug!
•
This equipment must be grounded (earthed) via the supplied 3 conductor AC power cables. (If the supplied
power cables are not the correct on, consult your dealer.)
Barco – Hydra Compact – R5976568 – Revision 10 – February-2004
Do not defeat the purpose of the
____________________________________________________________________________________________
1. Introduction
1-4
Advertisement
Table of Contents
