Removing And Inserting The Hook-In Racks; Troubleshooting - Bosch HVA541NS0 Instruction Manual

Built-in cooker
Hide thumbs Also See for HVA541NS0:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 16
Remove the middle panel.
5.
Note: The middle panel is kept in place with rubber bushings
rather than retaining pins.
Clean the panels with glass cleaner and a soft cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, sharp or abrasive cleaning
aids or detergents.

Troubleshooting

Malfunctions often have simple explanations. Please read the
following notes before calling the after­sales service.
Problem
Possible cause Notes/remedy
The appliance
Circuit breaker
does not work.
faulty.
Power cut
The oven can-
The electronics
not be switched
are faulty.
off.
The clock dis-
Power cut
play flashes.
The oven does
Circuit breaker
not heat up.
faulty.
The function
selector has not
been set.
24
Look in the fuse box and
check that the circuit
breaker for the cooker is in
working order.
Check whether the kitchen
light works.
Switch off the circuit
breaker. Contact the after-
sales service.
Reset the clock.
Check the circuit breaker
and replace if necessary.
Set the function selector.
Fitting the door panels
Reinsert the middle panel.
1.
Note: Make sure that the panel is seated correctly. All rubber
bushings must lay flat against the outer panel.
Reinsert the inner panel.
2.
Note: All four fastening pins must engage in the holders
provided for them.
Refit the oven doors.
3.

Removing and inserting the hook-in racks

You can remove the hook-in racks for easier cleaning.
Removing the hook-in racks
The hook-in racks are each fixed to the side panels of the
cooking compartment at three points.
Grip the front of the hook-in rack and pull it to the middle of
1.
the cooking compartment.
The front hook of the hook-in rack will release from the hole.
Fold out the hook-in rack further and pull it from the rear
2.
holes of the side panel.
Hold the catalytic cooking compartment panel in place.
3.
Remove the hook-in rack from the cooking compartment.
4.
Inserting the hook-in rack
Hold the catalytic cooking compartment panel in place.
1.
Insert the hooks of the hook-in rack into the rear holes in the
2.
side panel.
Press the front hook of the hook-in rack into the hole.
3.
Problem
Possible cause Notes/remedy
The door glass
is broken.
Fruit juice or
Moist cake or
albumen stains
meat juices.
on enamelled
surfaces.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Incorrect repairs may result in significant risk to the user.
Switch off the appliance.
Contact the after-sales ser-
vice.
Harmless change in the
enamel, cannot be
removed.

Advertisement

Table of Contents
loading

Table of Contents