Table of Contents
Advertisement
Removing and fitting the appliance door
If the oven is very heavily soiled, the oven door can be removed
for easier cleaning. Normally, however, this is not necessary.
Removing the appliance door
Open the oven door fully.
1.
Lock both hinges on the left and right using the locking
2.
pin (a).
Note. The locking pins must be fully inserted into the holes in
the hinges.
Grip the oven door on either side with both hands and close
3.
the oven door by approx. 30° (b).
Raise the oven door slightly and pull it out.
4.
Note. Do not fully close the oven door. The hinges could
become bent and the enamel could be damaged.
Fitting the appliance door
Grip the oven door on either side with both hands.
1.
Slide the hinges into the slots in the oven (a).
2.
Note. The notch below the hinges must engage into the
frame of the oven (b).
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service, as you may be able to
remedy the fault yourself.
:
Risk of injury!
Incorrect repairs are dangerous. Repairs may only be carried
out, and damaged power and gas lines replaced, by an after-
sales engineer trained by us. If the appliance is faulty, unplug
the mains plug or switch off the fuse in the fuse box. Shut off
the gas supply. Contact the after-sales service.
Lower the door downwards.
3.
Remove the locking pins.
4.
:
Risk of injury!
Do not reach into the hinge if the oven door falls out
unintentionally or a hinge snaps closed. Call after-sales service.
Removing and inserting the hook-in racks
You can remove the hook-in racks for easier cleaning.
Removing the hook-in racks
The hook-in racks are each fixed to the side panels of the
cooking compartment at three points.
Grip the front of the hook-in rack and pull it to the middle of
1.
the cooking compartment.
The front hook of the hook-in rack will release from the hole.
Fold out the hook-in rack further and pull it from the rear
2.
holes of the side panel.
Hold the catalytic cooking compartment panel in place.
3.
Remove the hook-in rack from the cooking compartment.
4.
Inserting the hook-in rack
Hold the catalytic cooking compartment panel in place.
1.
Insert the hooks of the hook-in rack into the rear holes in the
2.
side panel.
Press the front hook of the hook-in rack into the hole.
3.
Malfunction
Possible cause Solution
The appliance
Power cut
does not work
Faulty circuit
breaker
The oven light-
Oven light is
ing has failed.
faulty
The flame
Normal build-up
(oven) does not
of dirt
burn through all
outlet openings.
The door panel
Normal occur-
steams up
rence; caused
when the oven
by the differ-
heats up.
ence in tempera-
ture
--------
Check whether other
kitchen appliances are
working
Check in the fuse box to
make sure that the circuit-
breaker for the appliance is
OK
Replace the oven light.
(See section "Replacing
oven light")
The burner must be profes-
sionally cleaned.
Not possible; this has no
effect on oven performance.
11
Advertisement
Table of Contents
