Toro Reelmaster 3555 Series Installation Instructions Manual page 7

3. Tighten the 2 bolts securing each
roller-brush-bearing housing to the roller-brush
mounting brackets.
Installing the Drive Pulley
and the Belt
1. Restrain the reel for installation;
Reel for Installing Threaded Inserts (page
2. Install the drive pulley onto the groomer shaft
(Figure 13).
1. Drive pulley
3. Apply 242 Loctite (blue) to the flange-head bolt
and use the bolt to secure the pulley to the
driveshaft; refer to
Note:
Torque the bolt to 20 to 26 N∙m (15 to
19 ft-lb).
Important:
If you do not properly torque the
bolt, the bolt will come loose.
4. Install the belt onto the pulleys as follows:
•
Loop the belt around the drive pulley and
then over the top of the idler pulley
14).
Restraining the
Figure 13
2. Flange-head bolt—torque
to 20 to 26 N∙m (15 to 19
ft-lb)
Figure 13.
12).
1. Drive pulley
2. Idler-pulley assembly
•
Start the belt on the driven pulley
15).
•
Use a 9/16-inch deep-well socket to rotate
the brush assembly and guide the belt onto
the driven pulley
g192352
(Figure
1. Belt
Important:
are properly seated in the grooves in each
pulley and that the belt is in the center of the
idler pulley.
7
Figure 14
3. Belt
4. Driven pulley
(Figure 15).
Figure 15
2. 9/16-inch deep-well socket
Ensure that the ribs on the belt
g192353
(Figure
g020390