Toro Reelmaster 3555 Series Installation Instructions Manual page 4

Installing the Additional
Weight Parts Not Included
in the Kit (5-inch Electrically
Driven Cutting Units; 7-inch
Hydraulically or Electrically
Driven Cutting Units)
Install the weight parts to the cutting unit as shown in
Figure 6; refer to Additional Parts That Need to be
Ordered (page 4).
If installing brush kit 133-0153, discard the weight and
fasteners included with the brush kit (do not use).
Additional parts that need to be ordered
5-inch electrically driven,
7-inch hydraulically or electrically driven
1. Weight plate
2. Carriage bolts (5/16 x 2
inch)—Part No. 3230-6
3. Bolts (5/16 x 1/2
inch)—Part No. 322-1
Additional Parts That Need to be Ordered
Part Part No.
Weight 132-0735-03
Carriage bolt 3230-6
Bolt 322-1
Washer 3256-23
Flange nut 104-8300
Figure 6
4. Washers (5/16 inch)—Part
No. 3256-23
5. Flange nuts (5/16
inch)—Part No. 104-8300
6. Weight—Part No.
132-0735-03
Quantity
1
2
2
2
2
Installing the Roller-Brush
Plate
1. Slide the excluder seal outward until the lip seals
are in light contact with each bearing housing
(Figure 7).
g032168 1. Bearing housing
2. Remove the cap from the groomer drive box.
1. Cap
3. Ensure that the roller-brush pivot plate is
configured so that the idler-pulley assembly is
installed on the bottom as shown in
To change the roller-brush pivot plate to a
right-drive configuration, refer to
4
Figure 7
2. Excluder seal
Figure 8
Figure
Figure
g027192
g283858
9.
10.