Toro Reelmaster 3555 Series Installation Instructions Manual page 3

Note:
Do not remove the bolts. Keep the flange
locknuts for future assembly.
5. Position the left or right roller-brush-assembly
mounting brackets onto the roller-bracket bolts
(Figure 4).
Figure 4
1. Left roller-brush assembly
Important:
Attach the mounting brackets
for the roller-brush assembly directly to
the top surface of the side-plate mounting
flange of the cutting unit. Do not put spacers
between the roller-brush mounting brackets
and the side-plate mounting flanges. Save
the additional 6 mm (1/4 inch) spacers for
potential later use.
6. Secure the brush-assembly mounting brackets
to the cutting-unit side plates with the previously
removed nuts.
g032172
2. Roller-brush mounting
bracket
Installing the Weight
Included in Kit 133-0153
(5-inch Hydraulically Driven
Cutting Units)
Install the weight to the cutting unit as shown in
5 (parts included with brush kit Model 133-0153).
Parts included with brush kit 133-0153
5-inch hydraulically driven
1. Weight plate
2. Carriage bolts (5/16 x 1
inch)
3
Figure 5
3. Flange nuts (5/16 inch),
torque to 20 to 26 N∙m (15
to 19 ft-lb)
4. Weight
Figure
g032167